The console outputs at that time are shown in the end of this post. But JR stopped without NAND read, issuing the following message.ġ) review the solder part and partial re-soldering ( but finally failed)ģ) re-connect the USB connection of the JRP and PC,ĥ) select several menus of JR, namely such as powerup menu,
#How to install jr programmer drivers windows 10 install
To read NAND by using JR Programmer V2( Abbreviated as JRP below ),I soldered using Corona QSB Install Kit V3.Īfter soldering ( in fact this was poor soldering), anyway, I have a Corona V1 xbox360, and this is a first time RGH execution.
So now i am on a mission to find out if its the NAND or a Dead CPU I have done many RGH's before so i don't think i killed the CPU I didn't even lift any pads. He Reballed the GPU and still had 0022 he looked all over for Traces and all looked fine, He said " It does cycle a few times before throwing the 0022 error, which leads me to believe that it could be NAND related, or a component that failed - one that I can't locate (other than the GPU)". I flashed it back to stock with a Bad Block tried to turn it on still RROD so i sent it off to xJonnyGunsx Some of you may know him. It just would not boot I did read the NAND and got the bad blocks as you can see down there.
So i tried the RGH1 it is on dash 13604 because i saw some where that Xell should work with RROD still. So i got this console off eBay, I forgot the Error it had but i think it was 0022 or 0102.